C
Copyrighted and All Rights Reserved 2023-2024 Season Webmaster: John Morin Since 2017
Mississippi Valley Associated Railroaders Within the Carleton Place and Surrounding Area Since 1987
STEP 3: I keep the end pieces in from ends about 1/32”. If the plywood warps any, it will still allow the Modules to fit tightly. Drill, glue and screw the blocks and cross pieces. Check for your foam base thickness. Then check for squareness. You should have a measurement of 41 11/16” when measured diagonally.
HOMEPAGE
PREVIOUS
NEXT
STEP 2: My blocks are 2 5/16” thick. This is so I can use 1 ½” foam base. If you want to use 1” foam, cut the pieces 2 13/16” thick. Countersink for the screws. Plywood will split. I use #8 countersink and #8 by 2 inch screws. Drill, glue and screw.
MENU